Sparkling Snowflakes Pillar Candle
By Andrea Rothenberg
Materials:
•White pillar candle, 6” tall, 3” wide
•JewelCraft Snowflake Photo Tintz
•8” JewelCraft White/Iris/Crystal Beaded Trim
•9 JewelCraft 7mm Crystal AB Cabachons
•JewelCraft True Love Bead Mix
•Therm O Web Peel n Stick™ ¼” double sided adhesive
•Beacon™ Gem-Tac™ Permanent Adhesive
•Scissors
•Ruler

Instructions
1) Wrap the Photo Tintz around the candle and make a mark where ends meet. Draw a straight line on the back, adding ¼” for overlap. Cut off the excess. Adhere strips of the Peel n Stick™ tape along the edges on the back of the Photo Tintz. Add a few more strips in the center. 2) Peel off the backing on the strip along the bottom edge. Adhere the ribbon area of the beaded trim along the adhesive to hold it onto the back. Apply another strip on the ribbon area of the trim to stick to the candle.
3) Peel of all of the backing from all of the tape strips. Adhere the Photo Tintz with the beaded trim to the candle, with the trim hanging at the bottom along the table.
4) Apply a strip of tape along the top and bottom edge of the Photo Tintz going around the candle. Working over a piece of paper or a paper plate, sprinkle the bead mix over the tape, making sure beads stick to the tape all the way around the candle.
5) Use the Gem-Tac™ to adhere the cabachons onto the Photo Tintz as pictured or as you desire for extra sparkle and shine.
**Most pillar candles only burn down the center, leaving the sides intack. Make sure you monitor your candle to make sure that the flame does not come close to the edges.