Rhinestone Snowflake Card
By Lauren Johnston
Materials:
• JewelCraft:
o Crystal Rhinestones: Sizes 12, 16, 20
o Snowflake Photo Tintz
• Cardstock:
o Black Glossy
o Silver Glossy
• Large Snowflake Stamp from Rubber Stampede
• Merry Christmas Stamp from DeNami Design
• ColorBox Pigment Stamp Pad: Black
• Black Fine Detail Embossing Powder
• Scissors
• Double-stick Tape
• Gem-Tac Adhesive from Beacon tm
• Heat Tool
• Double-sided foam tape

Instructions
1. On strip of Snowflake Photo Tintz, stamp Snowflake with Black Ink and emboss with Black powder. Be sure to heat slowly with the heat tool, as the Photo may scorch if it gets too hot.
2. Trim into square or rectangle, 1/8-1/4” from stamped design.
3. Stamp “Merry Christmas” or desired design on separate piece of Snowflake Photo Tintz, with Black Ink and emboss with Black powder.
4. Trim the stamped message down to desired size.
5. Cut piece of Silver glossy cardstock 5½ x 8½ and fold in ½ for a 5½ x 4¼” card (standard A-2 size).
6. Cut piece of Black cardstock slightly smaller than front of card and adhere with double-stick tape to the silver card.
7. Adhere the stamped snowflake and message to the Black glossy cardstock with double-sided foam tape.
8. Glue rhinestones to the snowflake in desired locations.